Tech Notes

Tech note

CO2 laser optics and coating types: ZnSe lenses, mirrors, phase retarders, protective windows

By
Shinhotek engineering
Published
2026-11-12

Ordinary glass does not transmit the 10.6 µm wavelength of a CO2 laser. Transmissive parts therefore use infrared materials centred on ZnSe, and reflective parts use metal substrates with infrared coatings.

PartMaterialCoatingRole
Focusing lens, f-theta lensZnSeAnti-reflection (AR)Focusing; low absorption is critical
Output window, protective windowZnSe, GeAnti-reflection (AR)Seals the resonator, keeps debris out
Beam delivery mirrorCu, Si, MoHigh-reflection (HR) metal or multilayerAbove 99% reflectivity, heat removal
Phase retarder mirrorCu, SiPhase retarding (λ/4)Turns linear into circular polarisation to remove cut-direction dependence
Output couplerZnSePartial reflection (PR)Lets part of the beam out of the resonator
Beam combinerZnSeSpecial coatingOverlays a visible pointer with the CO2 beam

Absorption sets lifetime. At 10.6 µm, ZnSe must be a very low-absorption grade. Higher absorption heats the lens, shifts the focus through thermal lensing and, in the worst case, peels the coating or cracks the lens. Anti-reflection coatings bring reflection per surface below 1%, cutting loss and back-reflection.

Mirrors. Copper conducts heat well and suits high power; silicon is light and flat and suits scanners and beam delivery. High-reflection coatings of gold or multilayer dielectrics exceed 99%, and the remaining fraction still becomes heat at high power, so water-cooled mounts are used.

Phase retarders. In CO2 cutting a linearly polarised beam cuts differently depending on direction. A quarter-wave phase retarder produces circular polarisation so quality is the same in every direction.

Cleaning and replacement. Dust and fumes on a coating raise absorption and accelerate damage. Clean gently with a suitable solvent and lens tissue, and replace parts that show scratches or coating discolouration. A protective window lets you replace a cheap window instead of the focusing lens.

Shinhotek supplies ULO Optics CO2 lenses, windows and f-theta lenses and laser optics with coatings from Optoman and Zenops.