Choosing a laser power meter and when to recalibrate: thermopile, photodiode, pyroelectric
- By
- Shinhotek engineering
- Published
- 2026-11-12
The sensor type sets what a laser power meter can measure. Knowing power range, wavelength, beam diameter and whether the beam is pulsed almost fixes the choice.
| Sensor | Suited to | Response | Wavelength |
|---|---|---|---|
| Thermopile | mW to kW CW and average power | Seconds | Broad, set by the absorber coating |
| Photodiode | nW to mW low power | Very fast | Limited by the semiconductor, needs per-wavelength correction |
| Pyroelectric | Energy per pulse | Per pulse | Broad |
Power range. Exceeding the maximum damages the sensor; near the minimum, noise dominates. Pick a sensor whose range puts your power around the middle. High power means air- or water-cooled thermopiles, low power means photodiodes.
Wavelength. Thermopiles are nearly flat across their coating range, while photodiode sensitivity changes with wavelength, so the measurement wavelength must be set. 10.6 µm CO2 needs a thermopile with a dedicated coating.
Beam diameter and aperture. The beam must sit inside the aperture with margin. A beam that spills over reads low; a beam concentrated on a point exceeds the power-density limit (W/cm²) and burns the coating. Measure focused beams away from the focus or through a diffuser.
Pulsed lasers. Average power with a thermopile, energy per pulse with a pyroelectric sensor. At high repetition rates, check the damage limit against average power.
Calibration. Absorber coatings drift over time. Manufacturers and calibration laboratories usually recommend recalibration every 12 months, and the certificate should state traceability to a national standard (KRISS, PTB, NIST) and the measurement uncertainty. That traceability is what quality audits ask for.
Shinhotek supplies LaserPoint power and energy meters and supports sensor selection and calibration requests.
